Also available across Hampshire and the South Coast

EV Charger Installation in Southampton

We install and commission home EV charge points across Southampton, Hampshire and the South Coast - 7.4kW units on their own dedicated circuit, fully certified.

Call 02381 550 111

Our Work

Newly installed Sync Energy EV charge point being tested on a Southampton house wall
Indra EV charger installed on a brick wall next to a garage in Southampton
Project EV charge point installed on a rendered house wall
Wall-mounted home EV charger with tethered cable installed on a brick wall in Southampton
Sync EV charger with tethered cable installed on a red brick wall in Hampshire
Hypervolt EV charger installed on a brick pillar beside a driveway in Hampshire

What's involved

Most Southampton homes can take a 7.4kW charger without a supply upgrade, but it depends on your incoming main fuse, the state of your consumer unit and the earthing arrangement. We check all three before quoting so the price you get is the price you pay.

We install on Victorian terraces where the cable run needs care, on 1980s semis with garages, and on newer estates with shared parking bays. We can also commission the charger without your vehicle present, so you don't need to be home or have the car on the drive when we finish.

Included as standard

  • Free site survey and load assessment before we estimate
  • Dedicated supply from the consumer unit with correct cable sizing
  • A separate consumer unit for the charger where needed, so you avoid a costly upgrade of an older fuse board
  • Earthing arrangement checked, with PEN fault protection where needed
  • Neat cable routing and clipping, indoors and out
  • Commissioning, app setup and a signed NICEIC test certificate

Common questions

How long does an EV charger installation take?

A straightforward install takes around three to four hours. Longer cable runs, a board upgrade or an earth rod add time, which we confirm at survey.

Do I need my fuse board upgraded first?

Not always. If your existing board has spare capacity and RCD protection suitable for the circuit, we can wire straight from it. Where it isn't, we often fit a small, separate consumer unit dedicated to the charger. That gives you a fully compliant, properly protected circuit while saving you the cost of upgrading an older fuse board that would otherwise need replacing first. If your existing board is genuinely unsafe we'll tell you honestly, but a separate unit is usually the more affordable route.

Quick estimate

Free estimate for EV Charger Installation

Send the details through and we'll get back to you with a price, usually the same day. Urgent? Call 02381 550 111.

Photos (optional)

Photos of the fuse board, socket or area help us price it accurately - up to 6 images.

We aim to respond within 24 hours with a price, or to arrange a site survey if the job needs a closer look. We only use your details to estimate this job. No marketing, ever.

  • NICEIC Approved ContractorNICEIC Approved Contractor
  • 18th Edition, 2391-52 & JIB Gold Card Qualified
  • £5m Public Liability and £250k Professional Indemnity Insured
  • Clear estimates, no surprises
Call Now